Reading BMW MEVD17.2.4 EEPROMFlash and ISN Code Using OBDSTAR X300 Classic G3

Equipment Setup:

• BMW Bosch MEVD17.2.4 TC1797 ECM
• OBDSTAR X300 Classic G3 Key Programmer
• OBDSTAR P004 ECU Bench Jumper
• OBDSTAR MP001 Programmer

Pinout Diagram:

• ECU to TOOL Connections:
  • A-Pin 1, 22, 40 to 12V (16)
  • A-Pin 27 to GND (4+5)
  • A-Pin 44 to CAN L (14)
  • A-Pin 43 to CAN H (6)
  • B-Pin 43 to GPT0
  • C-Pin 43 to GPT1

Connection Procedure:

1. Set Up the Wiring:
   • Use the OBDSTAR P004 ECU Bench Jumper to connect the MP001 Programmer to the BMW ECM according to the provided pinout diagram.
2. Connect the Devices:
   • Link the OBDSTAR MP001 to the X300 Classic G3 Key Programmer via the main cable.
   • Supply power to the MP001.

Operating the Device:

1. Navigate the Menu:
   • Go to: ECU Flasher >> ECM >> ECM V30.60 (select the newest version) >> mevd17 >> BMW BOSCH MEVD17.2.4 TC1797.
2. Start the Operation:
   • After connecting, select Start, then BENCH, followed by MP001 to enter the main operation page.
3. Ensure Connectivity:
   • Connect the G3 to an available internet source to ensure smooth operation.
4. Perform Reading Functions:
   • Execute the Connect, Read INT EEPROM, Read INT Flash, and Read ISN Code functions successfully.

Additional Support:

• The OBDSTAR X300 Classic G3 Key Programmer also supports various other BMW ECMs including EDC17C06, MED17.2, MEVD17.2 series, MSD80, MSD81, MSD85, MSD87, MSV80, and MSV90.

This comprehensive guide ensures that you can efficiently read and handle data from a BMW MEVD17.2.4 ECM using the OBDSTAR X300 Classic G3 in Bench mode, leveraging advanced tools and software for accurate diagnostics and maintenance.