Program 2017 Kia Sportage ID46 All Keys Lost By Autel KM100

This is how to perform Autel KM100 All Keys Lost for 2017 Kia Sportage QL ID46 by OBD. The car is with push start system. Following I’ll show how to do it.

KM100 KIA Sportage(EU) QL IMMO Car List

Year System Add key All keys lost Read password Remote learning
2016 Immobilizer By OBD By OBD × By OBD
2016 Keyless system By OBD By OBD By OBD No required
2017-2018 Immobilizer By OBD By OBD × By OBD
2017-2018 Keyless system By OBD By OBD By OBD No required
2019- Immobilizer By OBD By OBD × By OBD
2019- Keyless system By OBD By OBD Partially supported by OBD No required

1. Generate Remote
Put a Autel Smart Key into KM100 key slot:
Universal key >> KIA >> Kia Sportage(QL) 2016-2018 >> Generate universal key

2. Read Password

Plug MaxiVCI V200 into OBDII, wait it connected to KM100.
IMMO >> America >> 2017- >> Yes >> Hot function >> Read immobilizer password >> Read Pin code(46 smart card) >> Read pincode by OBD

The function is only supported for vehicles with 46-chip smart card. Please confirm whether the type of the key is correct!
Press “OK”.

You must turn off the Bluetooth function of the device and connect VCI to diagnostic tool within USB cable. Otherwise the function may fail!

Reading password, please wait…
The password that is read: 791243

3. Add Key
Add key >> Start
This function supports add key and all keys lost.
Performing this function will erase all existing keys, all the old keys must be relearned again to be able to use normally.
Press “Yes” to continue.
Turn the ignition off.
(Note: the instrument screen is black)
Open and then close the driver door once!
Autel MaxiIM KM100 will enter the security code automatically
OK >> Yes
Note! Click “OK” to complete the following steps:
Within 5s after OK is pressed, use the back or top of the smart key to hold down the START button for 5s until the anti-theft lamps flash.
(if the operation failed with the prompts, please remove the key case and re-execute the above steps so that the key chip can be successfully programmed.)
Programming succeeded.
Press “No” to compete.
Number of current keys: 1
Please exit the system to the vehicle selection menu and check if the key is programmed successfully.
Test the key, it does work well.

Leave a Reply

Your email address will not be published. Required fields are marked *